Address: 77-78, Bhagirathpura, Near Bharat Life Style Furniture, MR 4, Indore, Madhya Pradesh 452003
Email: info@wheelchairindia.com, mswindore@yahoo.com
Mobile: +91-9893025003
Mobile: +91-7772818883
Clutch
For convenience, your wheelchair has two mechanisms. The
drive and freewheel mechanism. It changes through the clutch.
The drive/freewheel mechanism is situated to the motor.
These levers will allow you to disengage the drive mechanism and have the
wheelchair in freewheel mode. Always
Leave in drive mode, the freewheel facility is there only to allow the chair to be pushed manually when the need arises(i.e., to store or push a tight space).
1. there is one clutch in each of motor.
2. turn to inside and parallel with the motor is in the
drive mode.
3. turn to the outside is in the freewheel mode.
Joystick
The joystick can be also changed from right to be left-hand
drive. The joystick is can be extended and shortened, you can take the
following way.
Footrest Plate
You can adjust your footrest up and down when it is not
suitable for yourself
Please adjust the extension tube through the screw in the
tube.
Taking off: To push the handle, makes it separated from the chair then turn the footrest outward and lift it up, it can be easy take-off.
Fixing Up: It is the reverse step of the Taking off.
Charger
When you want to charge your Zip Lite please make sure the
power is turned off and the freewheel levers are in the drive position. Please
insert B port insert your power supply hole. And please insert the A end into
the charger port in the controller
Attention: VISSCO advise all the users to use the VISSCO
charger, the different charger may cause the person to injure or hurt the
battery.
The wheelchair is designed to assist in your individual
mobility needs. Any usage outside which do not obey this manual may result
in damage to the chair or injury to the user or third party.
1. Do not lift the wheelchair by the armrests
2. Do not lift the wheelchair by the footrest brackets
3. You can program the controller in conjunction with your
supplier to fine-tune the wheelchair performance characteristics.
The VISSCO wheelchair is designed to operate on two Ul (2 x
35 Ah) gel, or sealed lead acid, maintenance-free batteries. Since they are
scaled, there is no need to check the electrolyte(fluid) level.
Charging.
One example of the indicator light on the charger gives
advice as follows:
• Red - Power on
• Amber - Battery charging
• Green - Charging complete
Please refer to the LED indicator description based on the
charging status of the charger.
1. The active user will need to charge the batteries after using
approximately more than 30% of battery capacity. As an inactive user, only
using from once a week to every other day, the recharge point would be at 50%
of the discharge.
2. In only using for a short distance each day, it is
advisable to charge at the end of each week.
Batteries should be kept fully charged at all times. They
must not be left in a discharged state if not using the unit for some UMC. The
batteries should be checked once a month and recharged as needed. To recharge
the, connect the charger to the Charging Port at the front of the VSI on the
charger.
ATTENTION. • Do not leave the charger plugged into the
Charging Port if the charger is not charging. This charger is for indoor use
only.
• Do not expose it to rain or water spray.
• Do not cover the battery charging pole.
• Always keep the battery dry, never to use it deeply
output, and never to charge it more than 12 hours.
How to improve the using of the battery.
1. Please charge the battery before you first using.
Usually, this time needs 8-10 hours.
2. Please make sure you have used all the power before the
second charging. Then to charge it for 8-11 hours.
3. Please make sure to cycle that for 5 times, so that your
battery is in the deeply cycle, can be used for long life.
4. A deeply cycle of the battery can protract the battery
life. So stunt people charge it ruleiessly, or store it without charge. may hurt
the battery, so the life is short than others.
Battery Installation.
1. Cut off the power
2. Make sure the Zip Litt is in the drive mode.
3. Cut the connection between the controller and the battery
case
CONTROLLER
Operation of the
controller.
1. On-Off Button: This button turns the joystick controller
(hereinafter referred to as VSI) on and off. Do not use this button to stop
them, except in an emergency.
2. Battery display: This is a 9-segment display, which
indicates if the VSI is switched on and gives the state of charge of the battery.
(from left to right 2 red bars, 3 amber bars and 4 green bars means battery
full)
3. Maximum Speed Indicator: This is a 5-segment display,
which indicates the maximum speed setting selected.
4. Horn Button: This button operates the wheelchair horn.
5. Speed Decrease Button: This button decreases the maximum
speed.
6. Speed Increase Button: This Button Increases the maximum
speed.
7. Joystick: This controls the speed and direction of the.
Push the joystick in the direction you want to go. The further you push it. the
faster the speed will be. Releasing the joystick will automatically engage the
brakes and stop them.
8. Charging Port for Off-Bord Charger: Only plug into this
port with the qualified charger certified by the original manufacturer of the.
The port should not be used as a power supply for any other electrical devices.
The behavior against the two statements above will void the warranty of them.
The controller can be fitted to suit either right or left-handed users.
VILCONTROLER
Fault solving of the
controller.
The Self-Help Guide (Table I) is intended to assist in the
location of a fault that may occur in a certain part (tithe. If after checking
out the fault from the table below and the fault is still showing, do not use
them. Turn off the power and consult your provider immediately.
TABLE
BATTERY GAUGE
|
POSSIBLE FAULT
|
SOLUTION
|
Controller alarm 2 times first, then 7 times
|
Turn on controller but joystick did not return to the neutral
position
|
Put joystick return to the neutral
position,then turn .
controller
|
Controller alarm 9 times and 9 Bars lighted
|
Possible controller fault or voltage is too low
|
Contact with provider or charge the battery
|
Controller Mart. times .d 8 Bars lighted
|
Possible controller fault
|
Contact with provider
|
Controller alarm 7 times and 7 Bars lighted
|
Possible joystick fault or disconnected
|
Put joystick return to the neutral
position or connect plug tightly
|
Controller alarm 6 times and 6 Bars lighted
|
Possible controller over current
|
Turn off controller the restart
|
Controller alarm 5 time and 5 Bars lighted
|
Right-hand brake fault or disconnected
|
Reconnect plug
|
Controller alarm 4 times and 4 Bars lighted
|
Right-hang motor disconnected
|
Reconnect plug
|
Controller alarm 3 times and 3 Bars lighted
|
Left-hand Make fault or disconnected
|
Reconnect plug
|
Controller alarm 2 times and 2 Bars lighted
|
Left-hand motor disconnected
|
Reconnect plug
|
Controller alarm 1 time and 1 Bar lighted
|
Low battery voltage
|
Charge the battery
|
USING THE
Your wheelchair is
made up of two main parts.
1. The seat part: different kinds of the scat arc design for
the requirement of the VISSCO set of the footplate and other small parts.
2. The driving parts: it is the best important of the Zip
Lite contains the controller, motor with gearbox battery, a set of the front
wheel, the rear wheel, and the anti-wheel.
1. Armrest
2. Joystick Controller
3, Charging Port
4. Scat
5. Standard Swing Away Leg rest
6. Front Castor (8" PU tire)
7. Rear Drive Wheel wide pneumatic urc,
8. Anti-tip Wheel 9.Push Handle (foldable for compact
storage and transportation)
Frame
|
Folding spraying steel frame
|
Rear Wheel
|
12" PU tyre
|
Front Caster
|
8" PU tyre
|
Armrest
|
flip-up armrest with soft PU pad
|
Side Panel
|
plastic
|
Backrest/seat
|
detachable soft sandwich mesh fabric cushion, double layers
|
Footrest
|
swing-away, detachable
|
Safety Belt
|
yes
|
Max. User weight
|
125kg
|
Max. Speed
|
6km/h
|
Distance per Charge
|
12km
|
Climbing Ability
|
8
|
Battery
|
24V/I 2AH, lead-acid battery
|
Motor
|
250wx2, without electromagnetic brake, its stop rein on the
resistance
Rear Wheel 12" PU tyre
|
Controller
|
homemade controller with a joystick, it can be changed for left hand
operation
|
N.W/G.W
|
40.4x44.9kg
|
Package
|
(IPC/carton, 720*450*820mm)
|
Overall Lenght
|
106cm
|
Overall height
|
96.5cm
|
Overall Width
|
62cm
|
Back height
|
55cm
|
Seat Height
|
55cm
|
Seat Depth
|
44cm
|
Seat Width
|
44.5cm
|
Folded Width
|
37cm
|
Armrest Height
|
72cm
|
Buy Online Click Here - Vissco Zip Lite Power Wheelchair
